1.      Selecting the number of pixels (led striplength) (ON/OFF contact disconnected (open) during setting!):

1.1.   Enter pixel setting mode - press and holdbutton 1 for at least 3 seconds.

1.1.1. Increasing pixelcount – click button 1 to increase pixel count by +1pix. Repeat thisstep until you have set the desired number of pixels.

(If you want to increase the pixel count faster, press and hold button1)

1.1.2. Decreasing pixelcount – click button 2 to decrease pixel count by -1pix. Repeat thisstep until you have set the desired pixel count.

(If you want to decrease the pixel count faster, press and hold button2)

1.1.3. Testing the effect– press and hold button 3 to test the current effect with new pixelcount.

2.      Selecting the light effect (ON/OFFcontact connected (shorted) during setting!):

2.1.   Selecting the light effect - click button1 to select next light effect. Repeat this step until you have set thedesired light effect.

2.2.   Testing the light effect – open and closethe ON/OFF contact to test the new light effect.

3.      Selecting the brightness (ON/OFF contact disconnected(open) during setting!):

3.1.   Selecting the brightness - click button2. Repeat this step until the desired brightness level is set. (Once themaximum brightness is set and button 2 is clicked again, the brightnesswill return to the minimum level)

3.2.   Quickly setting the maximum brightness -Press and hold button 2 for at least 3 seconds.

3.3.   Testing the brightness - Press and hold button3 to test new brightness level with the current light effect.

4.      Selecting the speed of the light effect(ON/OFF contact connected (shorted) during setting!):

4.1.   Speed selection - click button 2.Repeat this step until you have set the desired speed of the light effect.After each click you will see more pixels light up as an indication of thespeed you have selected. (Once the maximum speed is set and button 2 ispressed again, the speed returns to the lowest level)

4.2.   Quick maximum speed selection - press andhold button 2 for at least 3 seconds, until the maximum speed indicationlights up on the led strip.

5.      Selecting the pixel length (10cm or 3cm) +Changing the order of the R/G/B signals (ON/OFF contact connected(shorted) during setting!):

5.1.   Pixel length setting mode - press andhold button 1 for at least 3 seconds.

5.1.1. Changing the pixellength/RGB signal order - click button 2. Repeat this step until thedesired pixel configuration is set. After each click you will see an indicationon the led strip which mode you have selected.

5.1.2. Testing settings +saving settings - click button 1 to exit the Pixel length settingmode and test new pixel settings with the existing effect.